Runners of Injection Molds

Runners of Injection Molds

Runners of Injection Molds

The runner is the flow path by which the molten plastic travels from the sprue (i.e. the moulding machine) to the gates (i.e. the cavity). To prevent the runner freezing off prematurely, its surface area should be small so as to minimize heat transfer to the mould. However, the cross sectional area of the runner should be large so that it presents little resistance to the flow of the plastic but not so large that the cycle time needs to be extended to allow the runner to solidify for ejection. A good indication of the efficiency of a runner is the ratio of its crosssectional area to its surface area.

Subscription

    Contact Us

    Alleycho Precision Mold Technology Co., Ltd
    Factory: B1 Intelligent Industrial Park, Hongling Road, Nanhai, Foshan, Guangdong,China 528000
    Tell: +86-757-8230 4858

    Office: Room 404, Longxin mansion, No.500 LongXi Road, Liwan District, Guangzhou, China
    Tell: +86-181 9895 1483

    Email:  info[@]alleycho.com