Mold Set-up Guides on Toshiba Injection Molding Machines

Mold Set-up Guides on Toshiba Injection Molding Machines

Mold Set-up Preparation
Check if the mold matches the injection molding machine.
[1] Check if mold sizes matches the injection molding machine.

Mold width
H < Distance between tie rods, or Mold height, V < Distance between tie rods

* Refer to the specifications for the Distance between tie rods H / Max. mold height / Min. mold height.

[2] Injection volume check

[3] Check for mold locating ring and locating ring hole of stationary platen.

* The locating ring hole diameter may be changed according to the machine specification. Refer to the attached drawing, MOLD MOUNTING SPACE for checking.

[4] Check for sprue bushing and nozzle

[5] Nozzle touch check

H < Nozzle projection amount [message type="custom"] [one_half] * Projection amount of the standard nozzle i0.4 unit: 30 mm [1.18in] i1 and i1.5 units: 20 mm [0.79in] i2Y unit: 30 mm [1.18in] i2A and larger units: 65 mm [2.56in] [/one_half] [one_half_last] * Check if the clearances of nozzle heater and thermocouple to sprue bushing hole are secured. [/one_half_last] [/message]

[6] Clamping force checking

[7] Checking for ejecting rod position, diameter, and length

Feel Free to Contact Us if Any Questions