Swiveling the Injection Unit in Injection Molding Machines
Follow the procedure below to swivel the injection unit.
1) Continuously press [RETRACT] of the NOZZLE button to retract the injection unit to the retract limit.
2) Press [SERVO] of the PREPARATION button to turn off the motor before turning the power off.
3) Remove two pieces of clamp bolts fixing the injection unit and base.
When reassembling, tighten the bolts at the specified clamp torque. Refer to [Appendix ] separately provided.
4) Check that no one exists around before swiveling the injection unit.
i4～i8 over have ratchet drive mechanism.（ i3 below are without ratchet.）
NOTE: If swiveling is heavy, apply grease on the swiveling face.
NOTE: After returning the injection unit, follow the procedure of [6.1, Nozzle Alignment Check] to adjust the nozzle.
By TOSHIBA MACHINE CO.,LTD.
