Detect Circuit of Ejector Plate Retract on Injection Molding Machine
This device is the interlock circuit for the injection molding machine by means of detecting the retract limit of ejector plate inside the mold.
[1] Plug and Receptacle
Before using this circuit, complete wiring of the limit switch for the Ejector retract limit. The receptacle box is located on the operation side of the movable platen.
NOTE:
1) The limit switch is not included in the scope of our supply and must be prepared by the customer.
2) The limit switch should be of two-wire type. Electric limit switch such as proximity switch cannot be used for this type of machine.
3) Please consult separately when the use of the one other than the above is hoped.
1) The limit switch is not included in the scope of our supply and must be prepared by the customer.
2) The limit switch should be of two-wire type. Electric limit switch such as proximity switch cannot be used for this type of machine.
3) Please consult separately when the use of the one other than the above is hoped.
The mold does not close unless both limit switches for ejector retract limit (LS32) and mold ejector retract limit are turned on. If the detection circuit is not used, install the short plug attached for the machine.
